Refurbished Feiyu Vimble 3SE(Ship to US ONLY)

It uses a built-in and rechargeable battery, of which are specs are 1300mAH, 7.4V, 9.62Wh.

Use the standard USB cable to connect with the USB port on the gimbal handle to charge the battery (charging adapter equipped by user) , smartphone charging adapter is supported.
Note: Vimble 3SE does not support quick charger.
When using 5V/2A charging adapter, the charging time is about 2.5 hours.

Indicator keeps solid red when being charged when the gimbal is off, and turns green when fully charged.

Make sure the phone holder side that has a LOGO is facing up, place the phone in the center and ensure that the back of the phone fits well with the phone holder.
Fine-tune the position of the phone left and right (as shown in picture below) until it can remain stationary at a horizontal angle (before the gimbal is turned on).

1) Low Battery
-the indicator flashes red light 3 times at a time.
2)Protection status
-rapid rotation of the handle to a certain speed is detected->The handle needs to be held by hand, or fixed on a tripod.
-overheat (55℃) of the motors is detected->make sure a smartphone is mounted and balanced on the gimbal.
-overload detected->make sure the axes are unlocked.
-Smartphone removed detected.

Support for Android smartphone, not support for iPhone.

Method One: Double tap the M button
Method Two: Manually rotate the phone holder

The main function of the joystick is controlling the gimbal/phone direction.

Both the speed and direction are adjustable by the Feiyu ON APP. Below picture shows the setting interface.

Single tap to switch among pan follow, pan&tilt follow(default) and all follow mode.
Double tap to switch between landscape and portrait mode.

Function 1: Control the shutter/recording for stock camera or third-party camera APPs (Bluetooth between gimbal and smartphone paired)
Function 2: Control the Feiyu ON APP:
Half-press: Focus
Single tap: Take pictures, start/stop recording
Press and hold: Switch between photo and video mode

When the gimbal is connecting with the Feiyu ON APP, push up (T) to zoom in, and push down (W) to zoom out.

There are two trigger buttons, namely upper button and lower button.
Upper button:
Press and hold: Switch to flash mode, release to switch back to previous mode. The function of this button can be customized by the APP as: switch between front/rear camera, Inception mode etc.
Lower button:
Press and hold: Switch to lock mode, release to switch back to previous mode
Double tap: Recenter the gimbal and switch back to pan follow mode
Triple tap: Switch between front and rear camera

Press and hold the Album button and the M button at the same time, release when hearing a beep sound, the indicator turns from flashing green quickly to slowly, that mean the initialization is done.

It is a port for expansion accessories, you can connect either the fill light or the Smart Tracking module with this port.

Double tap the M button to switch to portrait mode, and then rotate the gimbal 180° from the left to shoot in underslung angle.

The roll axis, which is on the back side of the phone holder.

Restart the gimbal, connect the APP and update the firmware again.
Note: during the update, make sure the gimbal is always on, and then APP is always running in the foreground

Observe if the indicator is solid blue, if yes, that means the gimbal is connected with another device.
What you need to do is reset the Bluetooth on the gimbal, or take the gimbal to another place (at lease 10 meters away) and try connecting again.

The Android version of Feiyu ON APP currently does not support recording 60FPS videos under 4K resolution. It is recommended to use the phone's stock camera for recording 4K60FPS videos after pairing the Bluetooth between gimbal and the phone.